February 13th, 2014
Duration: 20 minutesErection Level: 0% - completely flaccid
Notes:
I ended up deciding to do a 20 minute session today, so I can stay at full pressure for at least 10 minutes. Again, it took me about 10 minutes to get to full pressure in the Bathmate, which took me to 17.5cm. My dick was about as pumped up as usual afterwards, although it looked a little puffier, which I assume is due to being in the warm water for a longer period of time. I'll keep entering like this for about a week before I switch to entering hard so I can evaluate the merits of both approaches. Only 3 more days until I post my two week results and progress pictures.
Measurements
Pre-Bathmate (15 minutes before)
- Flaccid:
- NBPL - 3.6 inches (59th percentile)*
- BPL - 4.31 inches (90th percentile)
- Girth - 4.25 inches (n/a)
- Erect:
- NBPL - 6 inches (62nd percentile)
- BPL - 6.5 inches (82nd percentile)
- Girth - 5.25 inches (84th percentile)
Post-Bathmate (15 minutes after)
- Flaccid:
- NBPL - 3.75 inches (59th percentile)
- BPL - 4.5 inches (94th percentile)
- Girth - 5.1 inches (n/a)
- Erect:
- NBPL - 6 inches (62nd percentile)
- BPL - 6.6 inches (82nd percentile)
- Girth - 5.4 inches (84th percentile)
*These percentile ranks are from www.howlongismyschlong.com, which uses data from 3 scientific studies on penis size to classify size by percentile. The studies are not based on self-reported size, but on measurements made by researchers under controlled conditions.
There is so much misinformation and so many bogus products surrounding penis enlargement that when they discover the solution, no one will believe. So here goes; any male can permanently increase length and girth in the same way a bodybuilder adds mass and becomes larger. As you stress tissue, the body goes into a natural process of creating new cells making you larger. The question is not whether permanent enlargement is possible but instead, how do you safely stress penile tissue to promote cell growth? The answers can be found at MagnumRings.com
ReplyDelete